Stats

  • Locked Locked
  • Replies 6
  • Subscribers 126
  • Views 14349
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to correct for Turbo RuleFile warnings

RFStuff

Dear All,

I am using Turbo Tool Box in IC5141. I have created the Rulfilefor the foundry.

However I am getting warnning each time I open TurboTollBox as below:-

! Missing minSpacing rule for CONT drawing and PO1 drawing value set to 0.0.

Can anybody please tell:- Where I can change this value in the rule file ?

 

Also I tried to modify the Rule file. I couldn't figure out where I should do the cahnge.

Also when I try to enter the rules in TurboTool Form (Rule Files Utility) and save it, a form named /tmp/_leTbRules11270 comes up.

Which also gives warning as:-


------------------------ MISSING PHYSICAL RULES -------------------------
Some leTbRules are set to '0.0'. Toolbox commands may be affected if the
required physical rules are not established first.
_________________________________________________________________________

 

Some of my TurboCommands are NOT functioning as well.

 

Kind Regards,

 

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.