Stats

Locked Locked
Replies 3
Subscribers 125
Views 15947
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Restarting a long simulation from where it is stopped due to POWER FAILURE

RFStuff over 12 years ago

Dear All,

I have been running a simulation since past two days. It is based on both transients & PSS.

Unfortunately, due to power failure, the simulation was stopped. Now again I have to rerun it from the scratch.

In other words two days is a WASTE.

Is there a way, to start the simualtion where it is stopped.

Could anybody please reply to it.

Kind Regards,

Parents

RFStuff over 12 years ago

Whether PSS/Pnoise can be recovered in the same way ?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

RFStuff over 12 years ago

Whether PSS/Pnoise can be recovered in the same way ?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.