Stats

  • Locked Locked
  • Replies 4
  • Subscribers 126
  • Views 7178
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No option of "Current" in Output Noise of noise analysis

RAO VINAY

 Hello all,

            I tried to extract output noise current of a single MOS transistor. But in Analysis->noise, under "Output Noise" option row, it is showing only two option of "Voltage" and "Probe" but not "Current" as an option (figure is attached). How can I plot output noise current through noise analysis of ADE L? My versions are IC 614-06.14-512, Assura 4.1 USR2, MMSIM 0720.593 and EXT101. Thank you.

 

Regards,

Vinay Rao.

 

Parents

  •  Sorry, I was not clear enough. From "spectre -h noise" :

    The noise is computed at the output of the circuit. The output is specified with either a pair of
    nodes or a probe component. To specify the output of a circuit with a probe, specify it with the
    `oprobe' parameter. If the output is voltage (or potential), choose a `resistor' or a `port' as the
    output probe. If the output is current (or flow), choose a `vsource' or `iprobe' as the output probe.

    So you need to probe either a voltage source or an iprobe component - it will then measure the current flowing through that source or probe (the voltage source would probably be a zero-volt source).

    Regards,

    Andrew.

Reply

  •  Sorry, I was not clear enough. From "spectre -h noise" :

    The noise is computed at the output of the circuit. The output is specified with either a pair of
    nodes or a probe component. To specify the output of a circuit with a probe, specify it with the
    `oprobe' parameter. If the output is voltage (or potential), choose a `resistor' or a `port' as the
    output probe. If the output is current (or flow), choose a `vsource' or `iprobe' as the output probe.

    So you need to probe either a voltage source or an iprobe component - it will then measure the current flowing through that source or probe (the voltage source would probably be a zero-volt source).

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.