Stats

  • Locked Locked
  • Replies 3
  • Subscribers 126
  • Views 19322
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Running AC analysis after certain time of transient analysis

RFStuff

 Dear All,

One can run DC simulation at a particular instant of transient analysis.

However, is it possible for the same for AC analysis ?

In other words, I actulally want  as follows:-

I want to run transient for 10 us after which the circuit enters into certain state.

At this point I want to start AC analyis

Is it possible and how it can be achieved ?

Could anybody please tell.

Kind Regards,

 

 

Parents

  • You need to use the acnames and actimes parameters on the transient options form. acnames is a list of the names of the analyses you wish to run (so "ac" in this case), and actimes is a list of the times during the transient that you wish to run them at.

    Regards,

    Andrew.

Reply

  • You need to use the acnames and actimes parameters on the transient options form. acnames is a list of the names of the analyses you wish to run (so "ac" in this case), and actimes is a list of the times during the transient that you wish to run them at.

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.