Stats

Locked Locked
Replies 5
Subscribers 127
Views 13295
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

re-using schematic based device current measurement in a extracted view.

Newmedia over 12 years ago

Hello all,

I have a current measurement like this in my ade-xl measurement.

OP("/Ibias/MP_ka_ref_cas" "table_ids")

The problem is that this does not work anymore in extracted view based simulations, since the transistor is splited into multiple devices.

Is there a way to handle this problem.

Thank you,

Parents

Newmedia over 12 years ago

currently. I have to do something like this.
OP("/Ibias/MP_ka_ref_cas" "table_ids") +OP(/Ibias/MP_ka_ref_cas@1 "table_ids")+....
This means I have to change all of my testbench.
Thank you,
JW
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Newmedia over 12 years ago

currently. I have to do something like this.
OP("/Ibias/MP_ka_ref_cas" "table_ids") +OP(/Ibias/MP_ka_ref_cas@1 "table_ids")+....
This means I have to change all of my testbench.
Thank you,
JW
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.