I'm using ic5141 and I would like to automatically run a routine everytime I choose to run a simulation, either by pressing Simulation->Run or by pressing the "Netlist and Run"/"Run" icons.
I tried to follow the post on "automatically run a routine when a menu item is invoked from CIW or schematic window" - http://www.cadence.com/community/forums/T/25992.aspx but it didn't work.
Cold someone have any idea on how to proceed?
Thanks in advance.
you were right. There was an error message in the CIW about some other customization and the .cdsinit did not get loaded. But I didn't see it.
After removing the error and .cdsinit correctly loaded, everything ran smoothly, as you predicted. Thanks very much.