Stats

Locked Locked
Replies 9
Subscribers 126
Views 5420
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Connectivity->Update->Layout Parameters problem

Hi,

I am using virtuoso XL in cadence ic615.06.15.151. I noticed that Connectivity->Update->Layout Parameters do NOT update multiplier

parameter m of device in schematic. As a result, if schematic has been changed, and you tried to update layout parameters corrresponding to schematic, you are going to miss this kind of change, and you're going to find out when you run LVS. That's a big hassle. Is it a way to get around this ??

Thanks,

Parents

pham777 over 12 years ago

Yes, it works when I do Update Components and Nets. But that's mean I can NOT use Connectivity->Update->Layout Parameters ??
then what is the use of this method ??
regards,
HP
Cancel
Vote Up 0 Vote Down

Cancel

Reply

pham777 over 12 years ago

Yes, it works when I do Update Components and Nets. But that's mean I can NOT use Connectivity->Update->Layout Parameters ??
then what is the use of this method ??
regards,
HP
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.