Stats

Locked Locked
Replies 0
Subscribers 125
Views 2650
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem in ADE "Simulation completed, but the results may not be available"

Dear All,

I am facing following problem when I run simulation with ADE in Cadence 6.1.5.500. After the simulation is sucessfull, there is a warning "Simulation completed, but the results may not be available". So, in order to plot the resuts, I have to go to Results/Select in ADE which is very frustrating. I guess we can fix this problem by adding a command setEnVal(....) in .cdsinit file.

Does anyone know how to fix this?

Thank you very much.

Best Regards,

Rohan

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.