Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 13415
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DC sweep with ams simulator ?

isazulkc

Hi,

 I'm using IC5.1.4 and I would like to do a DC sweep simulation with ams on my mixed-signal design. However the DC sweep is not possible from the ams simulator GUI. So, how can I run a DC sweep simulation with AMS ?

Thanks,

Best Regards.

Kc.

Parents

  • Hi Andrew,

    Yes in this present case I can do the characterization I want with parametric analysis ( that is check an analog output controlled by a config register for different DC input current). It is only longer, that's why I was tring DC sweep.

     Regards,

     Kc.

Reply

  • Hi Andrew,

    Yes in this present case I can do the characterization I want with parametric analysis ( that is check an analog output controlled by a config register for different DC input current). It is only longer, that's why I was tring DC sweep.

     Regards,

     Kc.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.