Stats

  • Locked Locked
  • Replies 6
  • Subscribers 127
  • Views 7038
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

sweep variable "bs" in hb, then use VAR("bs") in output expression, not plot in ADEXL

Taoni
Hi,  

Maybe I found a bug recently.   (Cadence IC 615, mmsim 12.11 )

Firstly,  I sweep variable "bs" in hb, then use VAR("bs") in output expression, it can not plot when run in ADEXL,

but it can plot when run in Test Editor or ADE L.

if do not contain VAR() in output expression, it can plot correctly.

for example, it can plot:   getData("NF" ?result "hbnoise"),

but it fails when plot :  value(getData("NF" ?result "hbnoise") (660*VAR("bs")+150*(1-VAR("bs")))*(10**6) ) .

if I change  (660*VAR("bs")+150*(1-VAR("bs")))*(10**6)   to    660*(10**6),   it can plot again.

 so what is the solution ?

appreciate your helps.


Regards,

Tao
Parents
  • Taoni

    Hi Andrew,

    "sub-version  IC6.1.5-64bit.500.17"   

     

    Thanks.

     

    Regards,

    Tao 

Reply
  • Taoni

    Hi Andrew,

    "sub-version  IC6.1.5-64bit.500.17"   

     

    Thanks.

     

    Regards,

    Tao 

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.