Stats

  • Locked Locked
  • Replies 12
  • Subscribers 124
  • Views 19052
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ultrasim simulator Problem

archive

I built a simple resistive ladder for voltage divider circut with componenets in analogLib. When I tried to simulate this circuit with Ultrasim simulator, the intermediate nodes failed to show the output waveform excepting ground and supply nodes. I added them in the outputs list,tried save all method but none of them worked. It happened with both SPICE and Spetre netlisting formats. I tried this simple circuit when a complex circuit failed to simulate properly. Hence now I find that the resistor is not identified properly in the Ultrasim simulation. Is there any known solution for this probelm??

Thanks in advance for your suggestions


Originally posted in cdnusers.org by gunturikishore28
Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.