Stats

Locked Locked
Replies 8
Subscribers 126
Views 16157
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Parallel simulation with Cadence

Hey guys,

I am running a simulation that takes forever to be completed! It has some switched-cap circuits inside and currently I use moderate simulation and ASP is also enabled, with 16 threads and 24 cores. I wonder if there is any option to break the simulation into smaller parts and use several computers to run parallel simulation.

Thanks

Parents

Marc Heise over 12 years ago

To be honest, SpectreRF isn't my strong side, but Google is:
http://www.designers-guide.org/analysis/delta-sigma.pdf
There is a good community of designers, but I would advise to show that you put some effort into it before asking there.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Marc Heise over 12 years ago

To be honest, SpectreRF isn't my strong side, but Google is:
http://www.designers-guide.org/analysis/delta-sigma.pdf
There is a good community of designers, but I would advise to show that you put some effort into it before asking there.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.