Stats

Locked Locked
Replies 2
Subscribers 125
Views 13464
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADEXL retry test

How do you control the "retry test" behaviour of ADEXL? Here's the problem...

A transient sim has a convergence failure near the end of the analysis and ADEXL (I think) is restarting the sim automatically. The original results would have been good enough but I can't view them because the new sim is overwriting them. On the second attempt the sim fails at the same point and this time ADEXL does not retry and I can view the results.

Any ideas much appreciated - pdub

Andrew Beckett over 11 years ago

envSetVal("adexl.distribute" "numRetriesOnError" 'int 1)
I can't remember whether it's sufficient to enter this in the CIW, or whether it must go into the .cdsinit as well (so that the child ICRP processes pick it up) - sorry, don't have time to test right now.
Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel
pdub over 11 years ago

Thanks for your help. Using envGetVal the number of retries was set to 2 so that explains the behaviour.
Regards, pdub.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.