Stats

  • Locked Locked
  • Replies 3
  • Subscribers 125
  • Views 14208
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DC Temperature sweep at an offset

Flyyn Rider

Hi,

I am using Temperature DC sweep in my simulations using Cadence 6. Can I sweep temperature at an offset instead of DC? like for example at 2ms. 

Parents

  •  If you're asking if you can change the temperature during a transient at a particular time point, then the answer is yes (your question is quite confusing, because you refer to an "offset" - and you specify an offset in ms (offset is not the term I'd have used to describe a time, but a voltage or current offset). Anyway, if that's what you want, it can be done via the "Dynamic Parameter" checkbox on the transient analysis form in ADE.

    Regards,

    Andrew.

Reply

  •  If you're asking if you can change the temperature during a transient at a particular time point, then the answer is yes (your question is quite confusing, because you refer to an "offset" - and you specify an offset in ms (offset is not the term I'd have used to describe a time, but a voltage or current offset). Anyway, if that's what you want, it can be done via the "Dynamic Parameter" checkbox on the transient analysis form in ADE.

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.