Stats

Locked Locked
Replies 9
Subscribers 125
Views 9468
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Removing P&R boundary

Using Virtuoso XL (IC6.1.5-64b.500.8), a P&R boundary is automatically drawn when I generate all from source. I can re-adjust this boundary by going to Create->P&R Objects->P&R Boundary to draw a new boundary. However, I'll be designing this layout by hand so I do not need it. How can I remove this boundary?

I cannot select it and delete it (it does not seem to be selectable, and I don't think I have a corresponding layer in the tech file.. i.e. if I set all layers to non-visible, I still see the boundary). I can only re-draw it using the aforementioned steps.

Parents

Lynks over 11 years ago

Thank you for the replies. I was able to remove the boundary using Andrew's solution to right-click anywhere on the layout canvas and select Make PR Boundary selectable.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Lynks over 11 years ago

Thank you for the replies. I was able to remove the boundary using Andrew's solution to right-click anywhere on the layout canvas and select Make PR Boundary selectable.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.