Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 12978
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

problem with flattern cell view in layout

whitefan

hello,

      In schematic driven layout, when I use "GEN FROM SOURCE" option it creates single layer layout of each and every components and then I tried to flattern it by going into Hierarachy in menu and it will show multiple layers to me that's fine but when I select a layout of particular component then corresponding component in schematic should highlighted but this is not happening , mean suppose I have 4 capacitors than I never know which layout is of which capacitor.

  •  I assume you're using the "Flatten" menu item under the Edit->Hierarchy menu. You shouldn't do that.

    Instead, increase the display depth (usually the shift-F bindkey, or on Options->Display (set the Display Stop Level to 32) or on the Options tool bar you can set the display depth.

    At least I'm guessing that's what your problem was...

    Regards,

    Andrew.

  • Hello sir!!

     Thank you very much for the guidance , you were right about the steps I followed and thank you for the suggestion.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.