Stats

Locked Locked
Replies 1
Subscribers 125
Views 13399
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XL pin issue

I have a block that was copied from an existing cell and when I try to add new pins with the "generate selected from source" button I get the error (Bus net base name in name 'DAC2' matches a scalar net name that already exists) and is changes my new pin to a rectangle instead of a pin.

Any ideas on what my issue is?

Thanks

Parents

Marc Heise over 11 years ago

Hi Alpine,

the tool does not allow net names like "M0" and "M0<0>" to coexist. Do you have a DAC<2> net in you design and a DAC2 ? Try to void these situations.

Kind regards,
Marc
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Marc Heise over 11 years ago

Hi Alpine,

the tool does not allow net names like "M0" and "M0<0>" to coexist. Do you have a DAC<2> net in you design and a DAC2 ? Try to void these situations.

Kind regards,
Marc
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.