Stats

Locked Locked
Replies 2
Subscribers 126
Views 13027
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Assura Layout extract.rul debug

I am writing extract.rul for a IC technology and I am a beginner.

Is there a simple way to debug while running the extraction, i.e. the visualization of the resulting layers from geomAnd and geomAndnot operations?

Thanks,

Pietro

Parents

Quek over 11 years ago

Hi Pietro

You can do it as follows:

a. Enable ?keepData avParameter and set it to "namedLayers"
b. Run LVS
c. Look for the original/derived layers in VLW (Verification Layer Window)

Best regards
Quek
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Quek over 11 years ago

Hi Pietro

You can do it as follows:

a. Enable ?keepData avParameter and set it to "namedLayers"
b. Run LVS
c. Look for the original/derived layers in VLW (Verification Layer Window)

Best regards
Quek
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.