• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Error on trying to run ocean script with rpoly2 and rpolyh...

Stats

  • Locked Locked
  • Replies 6
  • Subscribers 125
  • Views 15483
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Error on trying to run ocean script with rpoly2 and rpolyh components in netlist

Lings
Lings over 11 years ago

 Hello,

I have a schematic desgined in Virtuoso schematic editor.  It has a resistor component and I used 'rpolyh/rpoly2' instance from 'PRIMLIB'. On using ADE for simuation, it completes without any issues. Then I tried to move the simulations to ocean script. On executing the ocean script following error message is issued:

 Error found by spectre during AHDL read-in.
    ERROR (VACOMP-1008): Cannot compile ahdlcmi module library. Check the log
        file input.ahdlSimDB//bsource.va.bsource_1.ahdlcmi/Linux/../ahdlcmi.out
        for details. If the compiler ran out of memory, use 'setenv
        CDS_CMI_COMPLEVEL 0', and try again. If the reason for the failure was
        a syntax error, contact your Cadence Customer Support representative
        with the netlist, log files, behavioral model files, and any other
        information that can help identify the problem.
    ERROR (SFE-91): Error when elaborating the instance bsource_1. Simulation
        should be terminated.
Cannot start up spectre.

I checked the ahdlcmi.out log and shows at the bottom: "gnumake: *** [obj/optimize/5.0/libahdlcmi.so] Error 2". If you want I can also put the whole log file.

The Cadence is installed in a 64 bit server and I'm accessing it remotely. The MMSIM version is MMSIM1110.

The question is, when I use 'rpoly1' instance it works fine for both ADE and OCEAN. But, if I use 'rpoly2/rployh' it works only in ADE and fails in OCEAN.

Could anyone help me out please?

Thanks,

Lings

  • Cancel
Parents
  • Lings
    Lings over 11 years ago

    Hi Andrew, 

    I posted the reply and it went to your admistrator moderation. I hope you got it. Let me know for any problems on it.

     

    Regards,

    Lings 

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Lings
    Lings over 11 years ago

    Hi Andrew, 

    I posted the reply and it went to your admistrator moderation. I hope you got it. Let me know for any problems on it.

     

    Regards,

    Lings 

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information