Stats

  • Locked Locked
  • Replies 1
  • Subscribers 126
  • Views 12834
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Measuring device parameters with Assura

PietroUser

I would like to measure the lenght or the perimeter of a device terminal layers lenght L1 and L2 as shown in the attached image.

Is there a simple way to do it?

 

Regards,

 

Pietro

 

 

  • Hi PietroUser

    You are trying to measure LOD (Length of Diffusion) parameters SA, SB, etc. Please use measureSTI command. The details can be found in $ASSURAHOME/doc/assuracommandref/assuracommandref.pdf.

    Best regards
    Quek

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.