Stats

  • Locked Locked
  • Replies 5
  • Subscribers 125
  • Views 16817
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Results Browser in IC5.10.41

ag2888

Hi,

I am using IC5.10.41 and wanted to know how can the below mentioned things be done.

1. Is there a way to print the numerous output expression values for a simulation that was previously done? Till now i have found that they would need to be re-evaluated using the calculator, which is all the more troublesome if we have numerous corner or parametric simulations!!
I believe in IC615 its possible to reload these expression values as there is a resultsDB for the same. Is there something like this for IC5141?

2. Is it possible to plot a particular signal for all the corners/parametric sweeps, using the result browser? As currently i see we need to individually select each corner result for the signal and plot it 

Parents

  • Hi Shawn,

     Thanks for the reply. I still have a couple of doubts though.

    While reloading the simulation directory it should be the psf directory that we should be loading right? The reason i ask this is that i face difficulty in doing it.

    If i run a simulation (say corner sim) in the distributed mode then i can see a folder by the job name in the path - ~/simulation/<Sch_name>/spectre/schematic/Corners/job. This folder i can load from the window.  But if i run a sim locally then each corner has a separate folder in the path - ~/simulation/<Sch_name>/spectre/schematic/Corners/<corner_name>. And this does not even appear in the Select Results window!

    Same is with the parametric sweeps. Each is a separate folder how do i load them in these cases?

    I have attached the snapshot for the errors/warnings that i get when i try to load the psf folder itself.

     

Reply

  • Hi Shawn,

     Thanks for the reply. I still have a couple of doubts though.

    While reloading the simulation directory it should be the psf directory that we should be loading right? The reason i ask this is that i face difficulty in doing it.

    If i run a simulation (say corner sim) in the distributed mode then i can see a folder by the job name in the path - ~/simulation/<Sch_name>/spectre/schematic/Corners/job. This folder i can load from the window.  But if i run a sim locally then each corner has a separate folder in the path - ~/simulation/<Sch_name>/spectre/schematic/Corners/<corner_name>. And this does not even appear in the Select Results window!

    Same is with the parametric sweeps. Each is a separate folder how do i load them in these cases?

    I have attached the snapshot for the errors/warnings that i get when i try to load the psf folder itself.

     

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.