Stats

  • Locked Locked
  • Replies 5
  • Subscribers 125
  • Views 16815
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Results Browser in IC5.10.41

ag2888

Hi,

I am using IC5.10.41 and wanted to know how can the below mentioned things be done.

1. Is there a way to print the numerous output expression values for a simulation that was previously done? Till now i have found that they would need to be re-evaluated using the calculator, which is all the more troublesome if we have numerous corner or parametric simulations!!
I believe in IC615 its possible to reload these expression values as there is a resultsDB for the same. Is there something like this for IC5141?

2. Is it possible to plot a particular signal for all the corners/parametric sweeps, using the result browser? As currently i see we need to individually select each corner result for the signal and plot it 

Parents

  • Hi Shawn,

    In the distributed mode i loaded the ~/simulation/<Sch_name>/spectre/schematic/Corners/job  folder. This works fine and does plot waveforms and expressions for all corners when i do a plot outputs.

     The issue is now for the locally run jobs. There even if i try loading the ~/simulation/<Sch_name>/spectre/schematic/ directory for the corner/parametric sweeps or even if i try to directly load the psf directory (for a single typical sim) it gives me the warning that no simulation data found.. And i have tried restarting the icfb a couple of times to check, but it still is the same warning. Have u faced this before?

     Also another weird issue that i am facing is that the results obtained for the simulations are different when i run the sim locally and in distributed host mode. Even though there is no change in the circuit or the sim setup.. Have u seen this kind of an issue before?

     

Reply

  • Hi Shawn,

    In the distributed mode i loaded the ~/simulation/<Sch_name>/spectre/schematic/Corners/job  folder. This works fine and does plot waveforms and expressions for all corners when i do a plot outputs.

     The issue is now for the locally run jobs. There even if i try loading the ~/simulation/<Sch_name>/spectre/schematic/ directory for the corner/parametric sweeps or even if i try to directly load the psf directory (for a single typical sim) it gives me the warning that no simulation data found.. And i have tried restarting the icfb a couple of times to check, but it still is the same warning. Have u faced this before?

     Also another weird issue that i am facing is that the results obtained for the simulations are different when i run the sim locally and in distributed host mode. Even though there is no change in the circuit or the sim setup.. Have u seen this kind of an issue before?

     

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.