Stats

Locked Locked
Replies 1
Subscribers 125
Views 13225
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Design variable sweep in dcmatch analysis is ignored

KoVe over 10 years ago

Dear,

Design variable sweep in dcmatch analysis is ignored. The following message is show in the log:

Notice from spectre during DC-Mismatch analysis `dcmatch'.
Ignore sweeping paramters in method=statistics.

How do I enable sweeping for the statistics method? In the past this was possible.

Kind regard,

Koen

Andrew Beckett over 10 years ago

Koen,

Don't know why this has changed (I did some tests, and see the change sometime during MMSIM13.1). My guess is that it didn't work properly, and then this has been suppressed. I can't find a record of why this was changed, so please contact customer support - hopefully it can be fixed.

Kind Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.