Stats

Locked Locked
Replies 3
Subscribers 125
Views 2049
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Howto run parametric simulations using Matlab & Spectre

Hi there,

is it possible to invoke Spectre from an matlab script? Here is what I want to do:

1.) Set initial width& length of transistors for a DUT
2.) Simulate with Spectre
3.) Read back results into Matlab
4.) Calculate "new" width & length values, jump to 2.)

How can this be done?

Cheers,
Marten

Parents

marten over 10 years ago

I agree, but how is it possible to change for example parameters of the simulators netlist (e.g length and width of NMOS, PMOS) ?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

marten over 10 years ago

I agree, but how is it possible to change for example parameters of the simulators netlist (e.g length and width of NMOS, PMOS) ?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.