Stats

Locked Locked
Replies 1
Subscribers 125
Views 684
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Virtuoso IC6.16 - DC simulation - Annotate DC OP failed

Hi everyone,

My issue is about a DC simulation.

When this one is finished, and I wanted annotate the DC operating points on the schematic, They are not displayed for all components.

For example, I've 2 dc sources, but the DC operating point is displayed only for one of them. I save all the points (Output -> Save all -> check boxes on "all").

If someone has the solution, thanks in advance.

Regards,

Parents

Andrew Beckett over 10 years ago

Not sure why this would happen, unless the annotation settings (I think in the View->Annotation Setup menus in the schematic editor) have been messed with (I think that's the menu item). If you can't find it, I suggest contacting customer support so somebody can take a look at your setup.

Kind Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 10 years ago

Not sure why this would happen, unless the annotation settings (I think in the View->Annotation Setup menus in the schematic editor) have been messed with (I think that's the menu item). If you can't find it, I suggest contacting customer support so somebody can take a look at your setup.

Kind Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.