Stats

  • Locked Locked
  • Replies 0
  • Subscribers 125
  • Views 12922
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SpectreMDL: How to set netlist parameters using cmd-line

marten

Hi there,

as part of an opimization algorithm we want to set width and length of a DUT based on previous mdl measurements.

  1. Start spectremdl with parameters initially set in the netlist
  2. read spectremdl measurement results
  3. calculate parameters for next simulation run and assign them to the netlist

So, is there a way to invoke spectre mdl with some netlist parameters/design variales?

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.