Stats

  • Locked Locked
  • Replies 2
  • Subscribers 127
  • Views 836
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ultrasim: Cannot get the rectangular coordinates of resistors in Netlist-Based EM/IR Flow

Cuong Truong

Hello,

Format in dspf netlist exists the value of length, width, coordinates but Ultrasim maybe realize only width and length.

r1765325 ...  $w=0.08 $lvl=17 $llx=16.2499 $lly=177.05 $urx=16.3299 $ury=177.32 $dir=1

Are there any option to get them (bold)?

In my EMIR report, I could not get the rectangular coordinates of resistor like that                                                                          

%failed  resistor layer current  width pathLength density  limit  neededwidth/#vias X1 Y1 X2 Y2  resistance
fail+595.61% r1765325 m1 692.692u 0.080 108.600 8.659m 1.245m 0.209 -1.00 -1.00 -1.00 -1.00 0.71

Therefore, I cannot see the violations in the layout. 

Could you help me fix the problem?

Thanks,

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.