Stats

  • Locked Locked
  • Replies 3
  • Subscribers 125
  • Views 13552
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

MAXACFREQUENCY

analogy

I'm using PSS + PNoise for jitter measurement.

I have plotted Edge-to-Edge Jitter (Jee) using PSS + PNoise (shooting engine) analysis as I vary MAXACFREQUENCY from 1GHz TO 5THz at 100GHz steps.Why do I see jitter measurement varying as I change MAXACFREQUENCY ?

For reference, I have PSSharmonics set as 7 while PNoise frequency is swept from 1Hz to 500MHz (full spectrum mode).

Parents

  • So I swept MAXACFREQUENCY but this time I plotted integrated noise (using PNoise's tdnoise integrated from 1Hz to PSSfundamental/2 i.e. 500 MHz).

    Although sweeping from 1GHz to 10THz , integrated noise varies from 8.77mV to 9.07mV, within first 250GHz integrated noise varies from 8.77mV to 8.98mV (error approximately 210uV).

    For additional reference, integrated noise varied from 8.77mV to 9.04mV (for next 750GHz, the error is as little as 60uV)

    What might be the reason for this error ? Any suggestions to keep it under control ?

    P.S. PSSharmonics = 7 for fundamental frequency of 1GHz.As said before, PNoise frequency was swept from 1Hz to 500MHz in full spectrum mode.

Reply

  • So I swept MAXACFREQUENCY but this time I plotted integrated noise (using PNoise's tdnoise integrated from 1Hz to PSSfundamental/2 i.e. 500 MHz).

    Although sweeping from 1GHz to 10THz , integrated noise varies from 8.77mV to 9.07mV, within first 250GHz integrated noise varies from 8.77mV to 8.98mV (error approximately 210uV).

    For additional reference, integrated noise varied from 8.77mV to 9.04mV (for next 750GHz, the error is as little as 60uV)

    What might be the reason for this error ? Any suggestions to keep it under control ?

    P.S. PSSharmonics = 7 for fundamental frequency of 1GHz.As said before, PNoise frequency was swept from 1Hz to 500MHz in full spectrum mode.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.