• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Cadence spectre save options are confusing

Stats

  • Locked Locked
  • Replies 3
  • Subscribers 125
  • Views 22583
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cadence spectre save options are confusing

jasongong
jasongong over 9 years ago

Hi All,

I found that the save options in ADE-> save all are very confusing.

there is no clear documentation on difference between nestlvl and subcktprobelvl.

i got an impression that nestlvl is for voltage probes, and subcktproblvl is for terminal currents.

consider following requirement: 

i try to save selected voltage signals and top to "top-2" level terminal currents.

if i choose "select signal to output(save)" to be "selected",  the subcktprobelvl = 2, select device current (currents) = all,

then simulation output selected voltage (which is correct) but output the terminal current from very bottom transistor to terminal

current which are 2-3 levels up.

if i choose  "select signal to output(save)" to be "lvlpub",  the nestlvl = 2,  the subcktprobelvl = 2, select device current (currents) = all,

then simulation output selected voltage and the terminal currents from top level down 2 level currents.

so it seems that nestlvl do affect the terminal current output but it is never specified in ADE or spectre manual in detail.

i am hoping that expert here can give a explanation on how different save options affect the voltage and current output.

thanks

jason

  • Cancel
Parents
  • Andrew Beckett
    Andrew Beckett over 9 years ago

    Jason,

    My limited checks seemed to show it was working OK. If you're seeing what you perceive as incorrect behaviour, you should contact customer support with a testcase that illustrates the problem, then we can work on getting it fixed (or we can clarify if it is indeed correct behaviour).

    Regards,

    Andrew.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Andrew Beckett
    Andrew Beckett over 9 years ago

    Jason,

    My limited checks seemed to show it was working OK. If you're seeing what you perceive as incorrect behaviour, you should contact customer support with a testcase that illustrates the problem, then we can work on getting it fixed (or we can clarify if it is indeed correct behaviour).

    Regards,

    Andrew.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information