Stats

Locked Locked
Replies 1
Subscribers 125
Views 3056
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem with Calibre LVS_ IC6

Hi everyone,

When I run Assura LVS and when Schematic and Layout don't match, I have three errors whith Calibre Lvs : - Nothing in Layout - Corresponding cells could not be identified - Nothing in Layout. And when I run Assura LVS and when Schematic and Layout match, Calibre finish with "Supply error detected. Abort on supply Error is specified _ aborting". The circuit is just a pmos2v . How can I resolve this problem please ?

Thanks,

Mohammed

Parents

Andrew Beckett over 9 years ago

Hi Mohammed,

You're describing problems you're having with Calibre, which is a Mentor Graphics (not Cadence Design Systems) product. So this may be better asked on a Mentor Graphics forum or to their customer support.

Kind Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 9 years ago

Hi Mohammed,

You're describing problems you're having with Calibre, which is a Mentor Graphics (not Cadence Design Systems) product. So this may be better asked on a Mentor Graphics forum or to their customer support.

Kind Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.