• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Transient simulation accuracy

Stats

  • Locked Locked
  • Replies 3
  • Subscribers 125
  • Views 16507
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Transient simulation accuracy

ymn2009
ymn2009 over 9 years ago

Hi, 

I am trying to simulate an ADC and while noting all the codes that are generated while applying a ramp input to the system I am getting different results for different simulation time. 

If I am running a 2us transient analysis (with a smaller voltage ramp) I am getting accurate results for the sampled voltage and while running proportional ramp for 10us I am getting different outputs for the region where the voltage ramp is same. Is there some simulation parameter I need to look for. The simulation results for all the accuracy settings (moderate, conservative and liberal) are same. I need to simulate for a 500mV ramp over the time of ~1.6ms. So its impractical to simulate it in chunks of 2us. Can anyone please help in this situation. 

Thanks

ymn2009

  • Cancel
Parents
  • Andrew Beckett
    Andrew Beckett over 9 years ago

    Yaman,

    It sounds rather unlikely that the simulator would be making such a huge error unless there was something fundamentally wrong in your simulation setup or more likely in the circuit or test bench itself. Circuit simulators (even when asked to run with very loose tolerances) typically don't make such gross errors. So without seeing your circuit, it's hard to know what the problem is - as I said. I suggest you talk to your supervisor, because clearly something is wrong, and if nobody can see it, nobody will be able to point you in the right direction.

    Regards,

    Andrew.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Andrew Beckett
    Andrew Beckett over 9 years ago

    Yaman,

    It sounds rather unlikely that the simulator would be making such a huge error unless there was something fundamentally wrong in your simulation setup or more likely in the circuit or test bench itself. Circuit simulators (even when asked to run with very loose tolerances) typically don't make such gross errors. So without seeing your circuit, it's hard to know what the problem is - as I said. I suggest you talk to your supervisor, because clearly something is wrong, and if nobody can see it, nobody will be able to point you in the right direction.

    Regards,

    Andrew.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information