• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Simulate fmax of a MOSFET

Stats

  • Locked Locked
  • Replies 3
  • Subscribers 125
  • Views 18654
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Simulate fmax of a MOSFET

Pyroblast
Pyroblast over 9 years ago

Hi guys,

I want to simulate the fmax of a mosfet. Does anyone know how this can be done? Can someone give me a tip?

Best.

  • Cancel
Parents
  • Pyroblast
    Pyroblast over 9 years ago

    Hi Andrew, I took a look at your colleague blog and to be honest and with all respect that blog doesn't say absolutely nothing about how to simulate the Fmax of a mosfet. Absolutely nothing. I have put together all the components. It doesn't say which analysis to perform, how to configure, doesn't say if we need to use any expression and it's funny that the author says:

    "So, for example, we can measure ft directly in simulation instead of extracting it from s-parameters as we would have to do if we tried to measure it in the lab. On the other hand, simulation also ignores all the higher order device behavior that designers do not specify. As a result, effects that can degrade design performance are ignored."

    but doesn't tell how.

    I took a look the the other entries in his blog and the same applies.

    So I remain in the same step.

    Any other suggestion?

    Regards

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Pyroblast
    Pyroblast over 9 years ago

    Hi Andrew, I took a look at your colleague blog and to be honest and with all respect that blog doesn't say absolutely nothing about how to simulate the Fmax of a mosfet. Absolutely nothing. I have put together all the components. It doesn't say which analysis to perform, how to configure, doesn't say if we need to use any expression and it's funny that the author says:

    "So, for example, we can measure ft directly in simulation instead of extracting it from s-parameters as we would have to do if we tried to measure it in the lab. On the other hand, simulation also ignores all the higher order device behavior that designers do not specify. As a result, effects that can degrade design performance are ignored."

    but doesn't tell how.

    I took a look the the other entries in his blog and the same applies.

    So I remain in the same step.

    Any other suggestion?

    Regards

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information