• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. noise summary parameters and noise simualtions

Stats

  • Locked Locked
  • Replies 3
  • Subscribers 125
  • Views 16103
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

noise summary parameters and noise simualtions

Jeni
Jeni over 9 years ago

Hi,

I have 2 questions:

1. When I use a NEGATIVE resistor to in schematic the noise simulations and noise summary ADD noise - why is that? 

2.In the noise summary there is a noise contributor described as .rg with parameter rn. I understand that  this is the gate resistance noise contribution, but what is the exact calculation of this?

After some investigation, I think that this does not come from the bsim model , since in my bsim model file, the gate resistance is not modeled. I think that it is coming from the simulator itself.

If someone could point me to the exact equation/calculation of this noise it would be fantastic! 

Thanks

Jenia 

  • Cancel
Parents
  • Jeni
    Jeni over 9 years ago

    Hi Andrew,

    Thank you for replying.

    Regarding the model, do you know how or where should I look for this explicit gate resistance you mentioned, which is not part of the BSIM model?

    I tried to change the rgx parameter inside the subcircuit model in the .scs file, but it had no effect on simulation results, therefore I suspect the simulator takes the resistance value from some other palce..  

    Thanks

    Jenia  

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Jeni
    Jeni over 9 years ago

    Hi Andrew,

    Thank you for replying.

    Regarding the model, do you know how or where should I look for this explicit gate resistance you mentioned, which is not part of the BSIM model?

    I tried to change the rgx parameter inside the subcircuit model in the .scs file, but it had no effect on simulation results, therefore I suspect the simulator takes the resistance value from some other palce..  

    Thanks

    Jenia  

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information