Stats

  • Locked Locked
  • Replies 4
  • Subscribers 126
  • Views 4768
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ead_workshop - ade-xl error message (1921)

rafaelon

Hi friends from Cadence,

My virtuoso is IC6.1.6.500.13.
I have an error with ade-xl,when I use the ead_workshop (Rapid Adoption Kit).
The ade-xl error message (1921) is the following:
"Failed to start new job after %d attempts. Possible reasons could be"
"1. The machine selected in the current Job Setup Policy is not reachable."
"2. The Cadence hierarchy is not detected, not installed properly or"
" not compatible on the machine selected in the current Job Setup Policy."
"3. Job Start script %s is not found on the remote machine(s).

Simulating others circuits, the ade-xl works without this message of error.
Do you know why this error is ocurring in the ead_workshop? How we could fix this error?

Thanks,

Rafael

Parents
  • Andrew,

    There are problems with EAD tool from adexl. We have the licenses required to use EAD. The tools are updated.
    The setup is correct. The problem is for adexl simulation with option: "Enable Electrical Data Capture for EAD Flow".

    We obtain the following message:
    INFO (ADEXL-2107): Job 23 timed out while pending after 300 seconds
    Timeouts are generally caused by a simulator nonconvergence or legitimate runtime.
    Timeout duration can be modified in the 'Job Policy Setup' dialog. For no timeout, enter nothing.

    First we think that the problem was the workshop mentioned before. But the same problem occur for different circuits.
    Could you help us?
    Thanks,
    Regards,
    Rafael
Reply
  • Andrew,

    There are problems with EAD tool from adexl. We have the licenses required to use EAD. The tools are updated.
    The setup is correct. The problem is for adexl simulation with option: "Enable Electrical Data Capture for EAD Flow".

    We obtain the following message:
    INFO (ADEXL-2107): Job 23 timed out while pending after 300 seconds
    Timeouts are generally caused by a simulator nonconvergence or legitimate runtime.
    Timeout duration can be modified in the 'Job Policy Setup' dialog. For no timeout, enter nothing.

    First we think that the problem was the workshop mentioned before. But the same problem occur for different circuits.
    Could you help us?
    Thanks,
    Regards,
    Rafael
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.