Stats

  • Locked Locked
  • Replies 6
  • Subscribers 125
  • Views 16362
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using variable for CDF Parameters in a netlist file

meredith

As a work around for pPar, is it possible to use a variable for a parameter in a CDL netlist file and pass the value of that variable down through hierarchy? 

Parents
  • meredith
    The length and width of transistors are combined to use the area of the transistor for comparison in the netlist. Area is defined as a parameter for the transistor but marked as not editable. If pPar is used for the length or width the variable passes to the lower level but the default value is used for the area calculation.
Reply
  • meredith
    The length and width of transistors are combined to use the area of the transistor for comparison in the netlist. Area is defined as a parameter for the transistor but marked as not editable. If pPar is used for the length or width the variable passes to the lower level but the default value is used for the area calculation.
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.