Stats

Locked Locked
Replies 3
Subscribers 125
Views 16519
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to stop blinking schematic net when its probed

GDCRA over 8 years ago

Hi,

When I am probing certain net in Schematic design, it keeps on flashing. Can anyone tell me how to stop it ?

Also, is there way to increase thickness of net when its probed ?

Thanks

Parents

Andrew Beckett over 8 years ago

OK, that normally would be using the layer purposes y0/drawing through to y9/drawing.

You can use the Display Resource Editor (from the Tools menu in the CIW) to alter the colour/blink/width etc of these layer-purpose-pairs.

Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 8 years ago

OK, that normally would be using the layer purposes y0/drawing through to y9/drawing.

You can use the Display Resource Editor (from the Tools menu in the CIW) to alter the colour/blink/width etc of these layer-purpose-pairs.

Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.