Stats

  • Locked Locked
  • Replies 3
  • Subscribers 126
  • Views 15256
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

viewing spectre simulation results right from the start

memphis

Hi to everyone!

We're looking for a solution for an apparently simple problem.

When starting a simulation with spectre, we want to look into the results right from the beginning.
We want to do this to evaluate the simulation immediately. This is sometimes necessary for long-lasting simulations to stop them if they are going into the wrong direction.

However, spectre seems to update the saved simulation data periodically in fixed time frames.
Thus, for long simulations we have to wait for a very long time to be able to take a first look at our saved outputs. Is there a command or a flag for spectre (MMSIM) that I can set to shorten this time frame?

We spent a lot of time searching for this option in the Cadence manuals without success. We are using IC6.1.6 and MMSIM14.1 but the problem is version independent since older and newer releases show same behavior in our setup.


Thank you for your help in advance.

Parents
  • Andrew Beckett

    You should also heed the advice given in the article that Quek refers to. Adjusting the minimum flush time is not too bad - it just allows quicker access to the results early in the simulation. However, there is a significant performance benefit that comes from writing the data in bigger chunks, and setting the maximum flush time rather defeats the benefit of that.

    I wouldn't anticipate that after a period of running a very long simulation it would be necessary to get updates more frequently than every 5 minutes. However, in the first few minutes I can see why you might want to ensure that something sensible is happening.

    Kind Regards,

    Andrew.

Reply
  • Andrew Beckett

    You should also heed the advice given in the article that Quek refers to. Adjusting the minimum flush time is not too bad - it just allows quicker access to the results early in the simulation. However, there is a significant performance benefit that comes from writing the data in bigger chunks, and setting the maximum flush time rather defeats the benefit of that.

    I wouldn't anticipate that after a period of running a very long simulation it would be necessary to get updates more frequently than every 5 minutes. However, in the first few minutes I can see why you might want to ensure that something sensible is happening.

    Kind Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.