Stats

  • Locked Locked
  • Replies 7
  • Subscribers 126
  • Views 21315
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

resistor noise simulation by transient analysis

rfham

Hi,

I am trying to run the simple example as depicted in the attached image, taken from Cadence's "Virtuoso Spectre Transient Noise Analysis" document, page 24.
link is support.cadence.com/.../ArticleAttachmentPortal;pageName=ArticleContent&sq=005d0000005nSd1AAE_20173303123103

But, I am not able to implement the resistor (with the user defined parameter kf) as required here!
here is my setup and simulation process:
1>insert instance "res" from analogLib in schematic editor

2>change its "model name" to say "res_mod" and also made a model file (res.scs)


3>then added this model file from ADE->Setup->Model Path. The text put in this model file is:


simulator lang = spectre
model res_mod resistor rsh=1k kf=10e-13

4>set following parameters at "tran" analysis.

I am getting error of following

looks the circuit is not stable, and i searched the forum and found the same topic of following link. but i cannot find the final solution.

https://community.cadence.com/cadence_technology_forums/f/38/p/31559/1340473#1340473

could you help to check this? thanks a lot.

Parents
  • rfham
    it is very clear now, thanks a lot, Andrew.
    have a good day!
Reply
  • rfham
    it is very clear now, thanks a lot, Andrew.
    have a good day!
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.