Stats

  • Locked Locked
  • Replies 3
  • Subscribers 125
  • Views 14318
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADE XL Timed Out Running Monte Carlo Simulation

spaceradlab

This is the first time we are trying a Monte Carlo Simulation so it is most likely a setup issue but I'm not sure where to look for additional clues.

We are able to run a 'Single Run' simulation of a simple circuit using ADE XL but when we try to run Monte Carlo Sampling of the same simple circuit we get

error ADEXL-2107  Job timed out while pending after 300 seconds

and the run status says 'running' but it never starts/finishes. 

What to try and where to look for additional clues ?

thanks

Parents
  • Andrew Beckett

    Do you get the same problem if you do a sweep or run several corners in ADE XL?

    Which IC subversion are you using (Help->About will tell you this in any of the windows in Virtuoso)?

    Regards,

    Andrew.

Reply
  • Andrew Beckett

    Do you get the same problem if you do a sweep or run several corners in ADE XL?

    Which IC subversion are you using (Help->About will tell you this in any of the windows in Virtuoso)?

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.