• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Parasitic exclusion

Stats

  • Locked Locked
  • Replies 5
  • Subscribers 125
  • Views 16300
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Parasitic exclusion

manudupouy
manudupouy over 7 years ago

Hello,

I was using parasitic filter from an extracted view to discover the worst influences. I understood that I could add some parasitics or include all parasitics of an extracted view. So, if I want to simulate my circuit with all parasitic excluding a net, I have to include all parasitics in my constraint window and deactivate the one I don't want. Logic. But, it would be more simple in this case, by default activating all parasitics (without including the long list of parasitcs) and only put in my constraint window the net I don't want the parasitics.

Is it possible?

Emmanuel

  • Cancel
Parents
  • Andrew Beckett
    Andrew Beckett over 7 years ago

    Hi Emmanuel,

    This can be done with a combination of parasitic filters (I'm assuming you're using the Parasitic Filters in the constraint view - selected via the Parasitics/LDE menu in ADE XL?).

    The idea is that you add a parasitic cell filter for C and R which means that it will include all parasitics by default, and then you'd add a normal parasitic filter for R and C where you turn off the parasitics for the specific nets. In the picture below I've done this (just for excluding the resistances on a particular net):

    Hope that's clear?

    Regards,

    Andrew.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
  • manudupouy
    manudupouy over 7 years ago in reply to Andrew Beckett

    Yes, it is clear. Thank you very much Andrew.

    I had tried this option but I was unsuccessful because, for caps, I only selected one net to deactivate all caps connected to that net. It didn't work. So, I concluded that was the wrong way.

    But you showed me it was the right way. And to deactivate caps, I have to select the two nets where the caps are connected.

    Whatever, it is fine now.

    Thanks again.

    Regards,

    Emmanuel

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • manudupouy
    manudupouy over 7 years ago in reply to Andrew Beckett

    Yes, it is clear. Thank you very much Andrew.

    I had tried this option but I was unsuccessful because, for caps, I only selected one net to deactivate all caps connected to that net. It didn't work. So, I concluded that was the wrong way.

    But you showed me it was the right way. And to deactivate caps, I have to select the two nets where the caps are connected.

    Whatever, it is fine now.

    Thanks again.

    Regards,

    Emmanuel

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information