Stats

  • Locked Locked
  • Replies 2
  • Subscribers 128
  • Views 13690
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Linear regulator operating point over input DC Sweep

Johanny Saenz

Hi all.

I'm sweeping the linear regulator input voltage on DC from 0V to maximum expected Vin. However, as the OTA that makes part of LDO is internally supplied by the output voltage, the simulation will never turn on the OTA and it will find a very stable point of operation in 0V. it is like the dilemma of chicken and egg. 

How I could force to start the OTA and calculate the minimim input voltage?

Thanks

Parents
  • Johanny Saenz

    When I run a DC sweep from higher to lower values, the simulation converge to the desired value in a certain interval. However, there is a remaining and non desirable stable point at the beginning of the sweep (upper values),which can be easily tackled using a nodeset statement set to the regulator output voltage.

Reply
  • Johanny Saenz

    When I run a DC sweep from higher to lower values, the simulation converge to the desired value in a certain interval. However, there is a remaining and non desirable stable point at the beginning of the sweep (upper values),which can be easily tackled using a nodeset statement set to the regulator output voltage.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.