Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 13337
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

display result from on-going simulation

Karev11

Hi,

In my case, I need to set output format to fsdb for spectre transient simulation. However, w. that change, I cannot load/update waveform while simulation is on-going, I can only do that after simulation finishes or when I stop it.

Is this intended? are there settings that can remove this limitation?

thanks,

Kevin

Parents
  • Andrew Beckett

    Hi Kevin,

    One of my colleagues had a CCR 1917977 related to update not working when compression was also enabled, but I think the best thing would be for you to contact customer support to investigate further. The CCR hasn't been resolved yet (strictly it was for AMS, but it may be similar for spectre). I've not re-checked with current spectre versions to check the behaviour - I'll leave that to my colleagues in customer support (since I'm travelling at the moment).

    Andrew.

  • Karev11
    in reply to Andrew Beckett

    Thanks Andrew for the reply

Reply
  • Karev11
    in reply to Andrew Beckett

    Thanks Andrew for the reply

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.