Stats

Locked Locked
Replies 3
Subscribers 125
Views 13699
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

LVS error

sjeur over 5 years ago

Hello

While performing LVS check for a device i am getting following error messages

1. malformed device

2. The layout cell is bound to multiple schematic cells.

I already checked the device parameters (w, l , m, no of gates) between schematic and layout all are same plus the layout is not linked to more than one schematics. I am not sure why getting these LVS errors.

Thank you .

Parents

Andrew Beckett over 5 years ago

Which LVS tool are you using?

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel
sjeur over 5 years ago in reply to Andrew Beckett

Assura
Cancel
Vote Up 0 Vote Down

Cancel

Reply

sjeur over 5 years ago in reply to Andrew Beckett

Assura
Cancel
Vote Up 0 Vote Down

Cancel

Children

Andrew Beckett over 5 years ago in reply to sjeur

To be honest, there's not enough information to go on. I would suggest you contact customer support (I would hope you've resolved it after 2 months; I was just revisiting my inbox for things I'd not had a chance to follow up on).

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.