Stats

  • Locked Locked
  • Replies 1
  • Subscribers 125
  • Views 13970
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pin placement does not show up

Nicolas Callens

Hi Cadence Forum,

I have a large amount of pins 4000+, and I want to generate pins and attach them to the corresponding nets automatically. I want to use Place -> Pin Placement, but for some reason there is no pop-up window... I have also tried to generate all the pins and attach them by using Place -> Analog -> Adjust Cell Pins but without success (Virtuoso crashes); normally this worked with other designs. The latter approach could be performed with smaller design, but with larger design I am getting problems.

I am using IC6.1.8.

Thanks

Kind regards,

Nicolas

Parents
  • Andrew Beckett

    Hi Nicolas,

    Please contact customer support over this.

    Andrew.

Reply
  • Andrew Beckett

    Hi Nicolas,

    Please contact customer support over this.

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.