Stats

Locked Locked
Replies 0
Subscribers 125
Views 12281
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

OP point print issue

Everytime i choose OP point print, ADE always goes back to the top of the design hierarchy, which is quite annoying. I need to go deeply many times to choose the device which i want to display OP point. Is there anyway to set the environment variable to ensure i can choose the device from the current hierarchy, not going back to top?

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.