Stats

Locked Locked
Replies 1
Subscribers 125
Views 10488
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Verilog-AMS Simulation speed issue while using $table_model for reading from a file.

RFStuff over 4 years ago

Dear All,

I was using $table_model to read data from a file in each event for 5 times.

But, now I need to use $table_model to read data from a file in each event for 25 times.

This significantly increases my AMS sim time. I am using only Verilogams models.

Is there any way to reduce the operation time while calling $table_model ?

Kind Regards,

Andrew Beckett over 4 years ago

I think this would be best handled via customer support. It's going to be very hard to guess what might be possible to improve without seeing the bigger picture.

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.