Stats

  • Locked Locked
  • Replies 4
  • Subscribers 125
  • Views 2458
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

calcVal failure: Job log says some outputs used by Calcval have failed, but they haven't.

Ernesto1

Hi,

I have a ran into a very frustrating problem with calcVal.

I have these tests selected:

AC_IF_BIST (test 0) uses expressions from AC_CALIB_IF_BIST (test 1) and config_schematic_schematic_ac (test 2).

For example, I have the following output expression in test 1 (expression red-underlined):

It runs normally when the 3 tests are run (Test 1 and Test 2 run first, test 0 does it at the end).

And I can normally plot that red-underlined output:

Then, on test 0, I call this output with calcVal like this:

Unfortunately, it fails:

When looking at the job log, I find the following suprising message:

Basically, the job log claims that the output above "'Gv_filter_out_BIST_in_out_dB" for test 1 "AC_CALIB_IF_BIST" has failed!

But I already showed above that in the same run the output expression for that test has been correctly evaluated.

I'm using Virtuoso ICADVM18.1-64b.

I'm not sure what to make of this.

Looking forward to your reply,

Best,

Ernesto

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.