• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Max Jop Policy for single test simulation with corners

Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 9459
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Max Jop Policy for single test simulation with corners

Senan
Senan over 3 years ago

Hello,

I would like to ask if if the "Max Jop Policy" can be used in single test simulation but with different corners'? so number of corneres can be run paralley to save simulation time.

I usually use it with multiple tests simulation and accelerate my simulation efficiently

Thank you

Regards

  • Cancel
  • Andrew Beckett
    Andrew Beckett over 3 years ago

    Yes

    • Cancel
    • Vote Up +1 Vote Down
    • Cancel
  • Senan
    Senan over 3 years ago in reply to Andrew Beckett

    Thank you Andrew for confirming me

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information