Stats

  • Locked Locked
  • Replies 6
  • Subscribers 130
  • Views 12549
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

When I open the simulation state which I create before, I can not reload the state and show the information below. What should I do to fix it?

SnowPine

Parents
  • Andrew Beckett

    I didn't find any report of this error when loading a state. Which IC sub-version are you using? (type getVersion(t) in the CIW).

    Perhaps you could try the following (enter in the CIW):

    _stacktrace=50
    sstatus(errsetTrace t)

    and then try loading it again. Please then post the stack trace (ideally by copy/paste rather than a screenshot - it's hard to copy text from a screenshot!)

    Andrew

  • SnowPine
    in reply to Andrew Beckett

    Thanks for your reply. It's IC6.1.8-64b.83 version. Now  I can save the spectre_state in the directory and can reload it. But if I save the spectre_state in the cellview, when I open and reload it, it shows nothing and becomes empty and shows error in the CIW.

Reply
  • SnowPine
    in reply to Andrew Beckett

    Thanks for your reply. It's IC6.1.8-64b.83 version. Now  I can save the spectre_state in the directory and can reload it. But if I save the spectre_state in the cellview, when I open and reload it, it shows nothing and becomes empty and shows error in the CIW.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.