Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 9774
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

pin map error after pex analyse in calibre

marzi

hi

I'm using 6.1.7 cadence and I  completed the layout of my design.

I have done DRC and lvs analyze without error but when I want to do pex analyze, after I did the calibre view setup I got this message that I don't know what should I do.


I'm using 65nm technology.

I'm looking forward to helping.

  • Andrew Beckett

    Calibre is a Siemens EDA (formerly Mentor) tool and this Map Calibre Device and Calibre View creation is their tool, and not from Cadence. Yes, it runs within Virtuoso, but it's not a Cadence tool. You would be better asking this on a Siemens EDA forum or to their customer support.

    Kind Regards,

    Andrew

  • marzi
    in reply to Andrew Beckett

    ok andrew thank you for your supporting.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.